Session Pricing
Straightforward Pricing, Fully Credited Toward a Build
Every fitting fee below applies in full toward any club assembled on our bench within 60 days of the session. No hidden bay fee, no charge for demo balls.
Single Category
Per Session $95One club category, start to finish.
- Iron, wedge, or putter fitting
- 45–60 minutes of bay time
- Full demo wall access
- Written dispersion summary
Driver & Wood Camber Match
Per Session $175Our signature session — bulge and roll curvature compared head to head.
- Strike mapping on your current driver
- 75–90 minutes of bay time
- Bulge/roll comparison across the demo wall
- Before-and-after dispersion report
Full Bag Assessment
Per Session $260Driver through putter, evaluated as one connected system.
- Every club category included
- Up to 2.5 hours of bay time
- Full set gapping report
- Priority build scheduling
Build Costs
What It Runs to Actually Build the Clubs
Fitting fees above are separate from parts and labor. Rough ranges below assume mid-tier component pricing — premium heads and shafts run higher, and your fitting fee is subtracted from any total.
| Build | Typical Range |
|---|---|
| Driver, head + shaft, camber-matched build | $420 – $720 |
| Fairway wood, single club | $260 – $420 |
| Hybrid, single club | $210 – $340 |
| Iron set, 7 clubs, steel shafts | $700 – $1,150 |
| Iron set, 7 clubs, graphite shafts | $900 – $1,450 |
| Wedge, single club | $150 – $230 |
| Putter, off-the-rack head, custom length/lie | $180 – $340 |
| Regrip, per club | $14 – $22 |
Not Sure Which Session You Need?
Call the studio or send a message and we'll recommend a starting point based on what's not working in your current bag.